Skip to main content
  • EZ-Adjuster Style Instructions

    Materials used: foam, anti-fog plastic film, elastic strap, adjuster.

    Download Full User Manual

     

    Step_1.png

    Step 1

    Clean hands with soap and water or hand sanitizer.

    Step_2.png

    Step 2

    Remove a single ClearMask™ transparent face mask from packaging and peel off the protective layer on the outward-facing side of the mask. For the medical version, no protective layer needs to be peeled off. Inspect for any damages, rips, holes or contamination. Do not use product if any damages or contamination are found.

    Step_3.png

    Step 3

    Position the mask in your hand with the foam facing inward and the nose cutout on top, towards your fingertips. Bring the mask towards your face, such that your nose fits into the nose cutout and your chin rests on the bottom foam piece.

    Step_3.5.png  
    Step_4.png

    Step 4

    With your other hand, take both the top and bottom straps and pull them over your head. The bottom strap sits around the base of the head, below the ears. The top strap rests higher at the back of the head, above the ears. Do not crisscross straps.

    Step_5.png

    Step 5

    Use the EZ-Adjuster in the back to adjust the mask by pushing inward to tighten or pulling outward to loosen the straps.

    Step_6.png

    Step 6

    Ensure proper fit and direct contact between the face and the foam with minimal gaps. Please exercise caution when signing or gesturing to avoid contact or scratches with the edges of the mask.


    Removal of EZ-Adjuster

    Removal_Step_1.png

    Step 1

    Clean hands with soap and water or hand sanitizer.

    Removal_Step_2.png

    Step 2

    Remove the ClearMask™ transparent face mask by pulling the straps up and over the head, loosening the adjuster piece if needed.

    Removal_Step_3.png

    Step 3

    Slowly pull the mask away from the face. Avoid touching the front of the mask or any liquid splatter on the mask.

    Removal_Step_4.png

    Step 4

    Dispose of the mask according to local biohazard safety regulation.

     
  • EZ-Adjuster Style Instructions

    Materials used: nonwoven polypropylene, anti-fog plastic film, elastic strap, adjuster.

     

    1_-_open_mask.png

    Step 1

    Orient the mask so that the wire nosepiece is at the top. Fully open the bottom and top panels, and bring both straps in front of the mask.

    2_-_place_mask_on_face.png

    Step 2

    Place the mask on your face so that the top panel rests over your nose, and the bottom panel rests under your chin.

    3_-_pull_strap_around_head.png

    Step 3

    Pull the top strap over your head and position it high on the back of the head. Next, pull the bottom strap over your head and position it at the base of the head, below the ears.

    4_-_tighten_both_straps.png

    Step 4

    Tighten both of the straps by pulling the EZ-Adjusters close to your head.

    5_-_press_nosepiece.png

    Step 5

    Using your fingertips from both hands, press and mold the wire nosepiece to fit the mask around the nose to achieve a secure fit.

    6_-_adjust_for_fit.png

    Step 6

    Adjust for a comfortable fit by holding the top panel down with your fingers, and pulling the bottom panel under your chin. Readjust straps as necessary to maintain a secure fit.